Events the 3rd and 4th of December

I will be heading out there an hour or so later than Chris, can meet you somewhere on Blanding if you want.

Hopefully someone will have some welding for me to do once i get out there.. Trying to shake this rust off me before i weld up my rear end.

Where is his house at? Jeef can u send me an address

He is down in Lake Asbury. I am sure he will be on here later to give you his address.

If you want to head out kinda early Chuck you can meet me and follow me to his place. ill probably leave my house around 9am. Shoot me a text or call me if ya want to follow.
343.3593

I'm actually gunna be headed from starke. I'm going to look at a explorer for my wife

Ok, well he lives in Russell Oaks, its off 209..
If you are coming from Starke you should take a left on 209, go down till you cross the tracks (there will be a red light there) then take a right. You go down a few miles and take a left onto County road 739b (I THINK thats the name of it)..
Once you turn onto 739b just keep going till you see Russel Oaks on your left, there are 2 subdivisions with that name, you will be entering the 2nd one. Its Russell Oaks and Russell Oaks II.
Once you turn in just keep going straight, you will come around a bend and see all the jeeps parked on the right. It should be damn near impossible to miss his house, you got his wifes jeep in the driveway, and theres sure to be a shitload of us out there.

2934 russell oaks dr. 32043

his address.

that works for me

Any one who wants to follow me, I'll be leaving my house (which is of blanding in o.p.) later in the 8'o'clock hour.

i have to go to by buddys dads shop and wrench on his ford not sure when ill be done but im defiantly going to troys

ok cool see evryone that shows up. its starts at 1 but probably wont start cooking til 2-3 that go get some wheelin done

can i get your number troy in case i get lost

yes 945-9627

Well today (3rd) was very productive. Got a bumper upgraded, an axle shaft replaced, did some fender trimming, tow points installed, and some frame strengthening. Thanks for all the help everyone. Oh yeah did a lil' wheeling too.

Lock~N~Low wrote:Well today (3rd) was very productive. Got a bumper upgraded, an axle shaft replaced, did some fender trimming, tow points installed, and some frame strengthening. Thanks for all the help everyone. Oh yeah did a lil' wheeling too.

Hey guys I owe a big thank you to everybody that helped me out today, And sorry i missed out on the wheeling.

piratex wrote:we should turn 1 and 2 and into one event.

i do that everyday sometimes i mix it up and do both at the same time

A big thanks y'all. The recovery points do look damn good

had fun today sorry had to cut it short. any wheelin for tomorrow?

sorry guys i couldnt make it maybe next time

i goda do a little better planing for next time